Jeep Repair: blower resistor, blower motor resistor, jeep wrangler

Question
Hello. I just brought 03 jeep wrangler x , and the heat fan only work on in high speed mode, I think a blower resistor is bad, but I don't know locate the resistor location .Please help me out. Thank you

Answer
REMOVAL
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE AIRBAG SYSTEM CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE AIRBAG SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.

CAUTION: Stay clear of the blower motor and resistor block (Hot). Do not operate the blower motor with the resistor block removed.

Disconnect and isolate the battery negative cable.
Remove the glove box from the instrument panel (Refer to 23 - BODY/INSTRUMENT PANEL/GLOVE BOX - REMOVAL).
Pull out the lock on the blower motor resistor wire harness connector to unlock the connector latch (Blower Motor Resistor Block- Typical).
Depress the latch on the blower motor resistor wire harness connector and disconnect the connector from the resistor.
Remove the two screws that secure the blower motor resistor block to the HVAC housing.
Remove the resistor block from the HVAC housing.