Jeep Repair: Instruction On Replacing Timing Chain Cover On 2000 4.7 v8, jeep grand cherokee, jeep grand cherokee limited

Question
I have been putting off replacing the timing chain cover on my gf's 2000 jeep grand Cherokee limited w4.7 v8. It all started with a pin sized hole, {on the aluminum (i'm guessing) right where the thermostat sits next to thermostat housing} squirting coolant out at a high pressure,  I put some 2part epoxy over it which stopped it for a few months. Then it Started leaking a bit worse and was very soft to the touch. I then realized it was the timing chain cover i needed to replace. So i j&b welded it to buy me some more time and now its that time! My girl had some nitwit work on it at which time he was asked to fix the leak so he replaced the water pump. THANKS BUT?     If you would please tell me if im replacing the right part and give me some instructions on replacing the timing cover I would be BEYOND appreciative.

Answer
TIMING CHAIN COVER
REMOVAL
Disconnect the battery negative cable.
Drain cooling system and remove viscous fan drive assembly. Refer to Group 7, Cooling System for procedures.
Remove radiator shroud. Refer to Group 7, Cooling System for procedure.
Disconnect both heater hoses at timing cover.
Disconnect lower radiator hose at engine.
Remove crankshaft damper. Refer to procedure in this section.
Remove accessory drive belt tensioner assembly Accessory Drive Belt Tensioner
Remove the generator and A/C compressor.
Remove cover and gasket Timing Chain Cover Fasteners
INSTALLATION
Clean timing chain cover and block surface. Inspect cover gasket and replace as necessary.
Install cover and gasket. Tighten fasteners in sequence as shown in Timing Chain Cover Fasteners to 54 N·m (40 ft. lbs.)
Install the A/C compressor and generator.
Install crankshaft damper. Refer to procedure in this section.
Install accessory drive belt tensioner assembly. Tighten fastener to 54 N·m (40 ft. lbs.)
Install lower radiator hose.
Install both heater hoses.
Install radiator shroud and viscous fan drive assembly. Refer to Group 7, Cooling System for procedure.
Fill cooling system. Refer to Group 7, Cooling System for procedures.
Connect the battery negative cable.