QuestionI know that this is not a distibutor but a sensor drive.
While driving my engine stopped running, I found that the gear had sheared several teeth. I need to know the procedure to install the new drive for the sensor.
AnswerOIL PUMP DRIVE AND SENSOR - 4.0L
If the CMP and oil pump drive are to be removed and installed, do not allow engine crankshaft or camshaft to rotate. CMP sensor relationship will be lost.
Disconnect electrical connector at CMP sensor (CMP Location - 4.0L Engine).
Remove 2 sensor mounting bolts (CMP and Oil Pump Drive Shaft - 4.0L Engine) or (CMP Location - 4.0L Engine).
Remove sensor from oil pump drive.
Before proceeding to next step, mark and note rotational position of oil pump drive in relationship to engine block. After installation, the CMP sensor should face rear of engine 0°.
Remove hold-down bolt and clamp (CMP Location - 4.0L Engine).
While pulling assembly from engine, note direction and position of pulse ring (CMP and Oil Pump Drive Shaft - 4.0L Engine). After removal, look down into top of oil pump and note direction and position of slot at top of oil pump gear.
Remove and discard old oil pump drive-to-engine block gasket
