Jeep Repair: Cant start jeep WJ model 2002, throttle position sensor, intake air temp


Question
QUESTION: While we were driving on the road , the engine light turned on, and the vehical stopped. I tried to start it but it wouldn't start at all. everytime i tried to start it, it would try to start but it would stop soon. Checked the petrol pump and it was working. It is a grand cheerokee .

ANSWER: find out what the code is for the check engine light.

---------- FOLLOW-UP ----------

QUESTION: tried to start the vehical and recived the following codes "0123 353 352 351 113 720 don't E" what does that mean

ANSWER: P0123-THROTTLE POSITION SENSOR VOLTAGE HIGH
P0351-IGNITION COIL #1 PRIMARY CIRCUIT
P0352-IGNITION COIL #2 PRIMARY CIRCUIT
P0353-IGNITION COIL #3 PRIMARY CIRCUIT
P0113-INTAKE AIR TEMP SENSOR VOLTAGE HIGH
P0720-OUTPUT SPEED SENSOR ERROR

its says DONE


---------- FOLLOW-UP ----------

QUESTION: Hi thanks for sending the messages. I moved the cam angle sensor (distributor ) anti clockwise and it started. when I tried to drive it, It moved for to about 50m and stopped, and the engine light as well as the following codes 351, 352, 353 DONE . appears again. Should i change the ignition coil? Is that the problem.

Answer
if u moved the distributor  then it could be bad or locked up.And that sensor on top is the cam sensor  U dont use wires any more  U have a coil pack rail. If u replace the cam sensor shaft  U will haft to take it to a dealer to have it timed back up    I think U might want to have a pro look at this for u.