Jeep Repair: Blower motor replacement, jeep cherokee country, motor shaft

Question
I need to replace the blower motor on my 1996 Jeep cherokee country, 200,000 miles

Answer
BLOWER MOTOR
REMOVAL
Disconnect and isolate the battery negative cable.
Disconnect the blower motor cooling tube Blower Motor

Remove the blower motor wiring from the retainer. Unplug the wiring connector.
Remove the blower motor and wheel assembly mounting screws.
Remove the blower motor and wheel.
Remove the blower motor wheel retainer clip and remove the wheel from the blower motor shaft Blower Motor Wheel

INSTALLATION
Press the blower motor wheel onto the blower motor shaft. Be sure the flat on the blower motor shaft lines up with the flat inside the wheel.
Install the retainer clip. The ears of the retainer clip must be over the flat surface on the motor shaft.
Be certain that the blower motor seal is installed on the blower motor housing Blower Motor Seal

Install the blower motor.
Install and tighten the blower motor mounting screws.
Connect the wiring connector and install the wiring into the retainer.
Connect the blower motor cooling tube.
Connect the battery negative cable.