Jeep Repair: 97 Wrangler Blower Motor, powertrain control module pcm, powertrain control module

Question
Hello, I have a 97 TJ and the blower motor needs to be replaced.  I have had the resister, and switches tested and they are ok and power is getting to the blower.  I have seen alot of directions on how to change/repair the resisters but nothing on how to switch out the blower itself.  Please Help.

Brad, St. pete, FL

Answer
BLOWER MOTOR
REMOVAL
Remove the battery from the battery tray. Refer to Battery for the procedures.
Remove the three screws securing the Powertrain Control Module (PCM) to the mounting bracket on the engine compartment side of the dash panel. Move the PCM away from the blower motor opening in the dash panel Blower Motor Remove/Install
Unplug the blower motor wiring connector.
Remove the three blower motor and wheel assembly mounting screws.
Remove the blower motor and wheel from the heater-A/C housing.
Remove the blower motor wheel retainer clip and remove the wheel from the blower motor shaft
INSTALLATION
Install the blower motor and wheel into the heater-A/C housing.
Install and tighten the three blower motor mounting screws.
Connect the blower motor wiring connector.
Install the PCM to the mounting bracket with three screws.
Install the battery in the battery tray. Refer to Battery for the pro