Land Rover Repair: 2000 Front Bumper Removal, fog lamps, 2 nuts

Question
John,

I'm trying to remove the front bumper on my 2000 Disco. I have a small dent in the corner that I want to try to knock back out. Anyway, I followed the repair manual procedure for removal, but I can't get the thing off. It seems like it is still attached to the frame somewhere in the center of the bumper.

Are there any additional fasteners that might not be indicated in the instructions? Any suggestions?

Thanks!

Answer
Hi Christian,

**************** follow-up *****
I've been searching for a possible answer to your Q and can only find this:

(workshop pages 76-2-11 & 76-2-12:)
Bumper assembly - front
76.22.08
Remove
1. Remove 14 screws securing LH and RH wheel arch liner extensions to wheel arch liners and bumper valance and remove extensions.
Note: 18 screws are used on 03 MY onwards.
2. Disconnect multiplugs from fog lamps.
3. Remove 2 nuts securing bumper valance side mountings to body.
4. Remove 4 nuts securing bumper to crush cans and remove bumper from body.
5. Remove 3 screws securing bumper to front cross bar.
6. Models with headlamp wash: Position container to collect screen washer fluid and disconnect hose from headlamp washer pump.

Could it be your crossbar screws?  Otherwise, I'm just as 'stuck' as you.

Regards,

JohnMc

********************************

I've never done this myself.

I've checked my notes and can't find anything that will help.  Check www.discoweb.org and go to the TECH section of this website. There may be a tip for this.

Best of luck,

JohnMc