Mitsubishi Repair: wont go into any gear, clutch master cylinder, eagle talon tsi

Question
first off its a 1990 eagle talon tsi (awd turbo)
the car ran fine before i did anything but now i have this problem.
new clutch kit, new slave cylinder, new shifter cables,
put all this stuff in and now wont go into any gear unless the car is off? but can put in any gear and then start it and drive it but then it wont come out of that gear.
here some things i found out to do
bleed the clutch may take more than once.
get a new clutch master cylinder
check tranny fluid
check and adjust linkage

got any other idea's

Answer
Hi, I would say the steps that you listed to me are right. Who put the clutch in? I would start there if it worked before the work was done. Also make sure you gear oil is good is good. Bring it back to the shop that put the new clutch in. It is possible there was a mess up there. If you installed it then bleed it first and then go from there. Also try checking you tranny mounts, if there gone they will give you these types of problems too. Hope this helps thanks,Kevin