QuestionMark thanks for your advice ,I got the bike started,but the engine hits 1000 degrees and when i try to put her into gear she cuts out immediatelly-.i've heard that i might have to re syncronise the carbs i am screwed help,regards- Jonny----------------------
Followup To
Question -
dear mark,the bike has been garaged for 25 years ,icant get a spark manually or with the electric start i bypassed the solanoid onto the starter motor still no result the ht leads seem ok im no mechanic and badly need some advice help! thanks, jonny
Answer -
Hi Johnny,
Trace voltage, ensure power is getting to all components of the ignition system.
Check breaker point contacts for rust, wear, corrosion, etc.. Check point gap, check condensors, check ignition timing, and spark plugs. Replace as needed.
Remove carbs and inspect float bowls for dried gas (varnishing). Clean as needed.
Change engine oil and filter. Change air filter.
Respectfully,
Mark Shively
AnswerJohnny,
You wrote: "I got the bike started,but the engine hits 1000 degrees..."
Mark: I'm not sure what you mean by this. Is it running hot?
You wrote: "...and when i try to put her into gear she cuts out immediatelly-.i've heard that i might have to re syncronise the carbs i am screwed help,regards....."
Mark: Try adjusting the clutch and clutch cable. The carburetors may or may not need synchronized. Were the needles or mercury level within specs when you synchronized them recently? If so, they should be fine. You can check again if in doubt.
Mark
