Nissan Repair: Nissan Sunny Door cannot be unlocked, door switch, hazard lights

Question
Carlos,

steps to program a remote, annoying but easy
step 1: get into the drivers seat, lock the door with the main switch
step2: put the key in and out of the ignition slot approx 8 times, you’ll see the hazard lights flash
step 3: after the hazards flash put the key in the ignition and turn to the on position
step 4: unlock and lock the door using the main door switch
step 5: press lock button on remote
step 6: unlock and lock the door using the main door switch
--- if using multiple remotes go to step 7, if only one go to step 8
step 7: if program multiple remotes hit the lock button on the second remote, then lock and unlock the door with the main door switch
----
step 8: turn key to off and remove from ignition
step 9: unlock the door with the main door switch
step 10: open and close the drivers door

try the remote and it should work  

Answer
Bharat,

If this is a question where does it not work?

Usually, if the door switch is stuck it will cause the remote not to work.  Check the door lock with a key and lock and then unlock and then try the programming process over.

Be sure the driver's door is shut, with you in the car.

Try a different remote to start with, sometimes one remote will be broken and it messes up the process.