Questionok, I noticed that you guys have answered some questions regarding IGN Switches. I believe mine is bad due to related symptoms on other questions. My Question is where is the IGN switch relay located? I want to be sure my problem is the switch and not the relay $90 part price difference! Also do you have to take the whole steering column off to replace JUST the IGN switch?
Answermore than likely your issue is not with the relay itself, they rarely go bad unless water as intruded them. I believe you can remove the ignition switch without removing the column here is what i have found hope it helps
Removal Procedure
Caution: Refer to SIR Caution in the Preface section.
•Disable the SIR system. Refer to SIR Disabling and Enabling in SIR.
•Remove the upper and lower trim covers. Refer to Steering Column Trim Covers Replacement .
•Remove the wire harness assembly (4) from the wire harness strap (5).
•Remove the wire harness straps (3) from the wire harness assembly (4).
•Remove the wire harness strap (2) from the upper tilt head assembly (1).
•Slide the turn signal switch assembly connectors (2) out from the bulk head connector (1).
•Pull the PASSKEY® III (2) off of the ignition lock cylinder case (1).
•Remove the key alarm connector (1) from the ignition lock cylinder case (2).
•Remove the 2 tapping screws from the ignition switch assembly (3).
