Small Engines (Lawn Mowers, etc.): Oil leaking from the oil Seal on a Honda GCV 160

Question
Hi How do you change the Oil seal on a Honda GCV160 over head cam? I have a Husky 2600 power washer model # HU80722. The unit never leaked oil from the shaft till i replaced the pump. When i changed the pump water came out but had no pressure. I did some research and noticed the key on the shaft had been pushed up into the oil seal. (just a slightly) I corrected the key on the shaft, replaced the pump and the machine worked great. The next day i noticed at lot of oil on the floor, i took the pump off and could see oil was dripping from oil seal around the shaft. I bought a new oil seal (Honda 92303-ZL8-003), but I'm not sure how to remove the old seal and put the new one on.

Answer
Watch these videos:

http://www.youtube.com/watch?v=mM96NYZzVrs

http://www.youtube.com/watch?v=8T38Nc7vm2I

Make sure you note how far the original is inside the housing, flush or inside just a little.

Run and test the engine...no need for the pump to be on the engine to test run the engine.

Eric