Small Engines (Lawn Mowers, etc.): Kohler Governor, dowel pins, crankshaft seal

Question
Hi John,
What is the easiest way to get at the internal governor on a Kohler cv493t engine? I am hoping that I don't need to dissassemble the engine completely! Already have the little stuff off the engine but complete dissassembly makes me kinda nervous.

Answer
Hello Erik:

>>The Following is a Basic Instruction File for Examining the Inside of a Small Engine and will Assist you in having Access to the Governor, Oil Pump (if Applicable), Cam and Crankshaft Gear. Any Input is Appreciated.
>>**This is a Simple Process. Drain the Oil and Remove the Engine to the Work Bench with the Oil Pan Facing Up. I have a Wooden Rest that was Especially Made to Hold the Engine when in this Position.
>>Using Fine Sand Paper, Remove ALL the Rust and Debris from the Crankshaft.
>>Remove ALL the Oil Pan Bolts.
>>After All the Oil Pan Bolts are Removed; Tap Lightly on the Sides of the Oil Pan to Loosen it from the Dowel Pins.
Sometimes you May have to Use a Flat Screw Driver or Chisel Between the Oil Pan/Sump at the Areas Neat to the Dowel Pin and Loosen  the Oil Pan/Sump.
>>When the Oil Pan is Removed, you can See the Governor Resting on Top of the Cam Gear.
>>****If Required: Lift Off and Replace with a New Governor. Check the Engine Block for Debris from the Old Governor and Wipe the Inside of the Block With a Rag, Until Clean. Set the Governor Shaft So it will be Resting on the Governor whine the Oil Pan is Replaced and Carefully Replace the Oil Pan. If the Crankshaft Seal Was Not Leaking, then Leave it Alone. It Should be OK. You can Easily Replace it While Mounted on the Machine if Required Later. Make Sure the Governor Stays in Contact with the Governor Shaft while Replacing the Oil Pan. Re - Mount the Engine to the Machine. Refill With Oil. Your Internal Governor May Differ.**  
>>You can View a Breakdown/IPL of this Engine at this Site Addy, http://www.smallenginepartswarehouse.com/parts.asp and Select the Shop Online Parts Look Up. Then Select the Model Tab. Then Select the OEM (Kohler) and Enter the Model and Spec Numbers (). Then Double Click on the Model in the Results Area. Now you can Select the Section of the Engine you Wish to View.
>>The Internal Governor Components are #'s 14 thru 17 in the Breakdown.
>>If you Hit a Snag or this Does Not Correct the Problem,  I Hope to be Here if You Require More Assistance. Hope this Helps. Let me Know What Happens, Please. May the All Mighty Bless You and Yours. Be Safe and Happy. Thanks.

Good Luck

Respectfully

John

PS: I am Allowed to Answer 5 Questions a Day. If you See I am Maxxed Out, then Try Submitting your Question at or Just After 8pm EST (US). My New Day Starts then. Comments and Ratings are Greatly Appreciated. Thanks.

Respectfully

John