Small Engines (Lawn Mowers, etc.): Tecumseh carburetor rebuild, question pool, spec numbers

Question
I have kit 631893A to rebuild carb on a 2.7 H.P. Tecumseh.
1) Does the 1" metal plate on the diaphragm go up or down?
2) Does the small 1/4" white valve seat? go at the top of the metal piece with threads or does it get pushed down inside to the bottom?
3) I assume the thinnest part of the needle faces down.  Is this true?
4) Does the black washer get pushed down on the metal piece with the threads as far as it will go?
Thank you!

Answer
Hello Roland:

>>Sorry for the Delay. This Question was Located in the Question Pool and I can Only Answer Questions from the Question Pool when I am Not Answering Questions here or at the Other Site I Answer Questions at.
>>I Use IPL's and Breakdowns for a Reference.
>>This is so I am Sure I Understand the Part you are Asking about.
>>I Require the OEM (Walbro, Zama, ect) and the Model Numbers Off the Carburetor. With these I can Locate a Breakdown of the Carburetor and Better Assist you.
>>Send me the Make, Model and Type or Spec Numbers Off the Engine, Please. With these I can Locate the Proper Manual and Better Assist you.
>>One of the Above should give the Correct Information I require to Locate the Proper Manual.
>>May the All Mighty Bless You and Yours. Be Safe and Be Happy. Thanks.


Good Luck


Respectfully


jbridger (John)