Small Engines (Lawn Mowers, etc.): snowblower light install, chipper shredders, customer service phone number

Question
I just purchased a Yard Machines 26", with 208cc powermore engine. I am going to install a light on it. The engine has two connectors. One for a light and the other for grip warmers. Do you know what the amp rating for each circuit is? If I use a light with to high of a wattage rating, will it cause any damage? Also, is that engine a Briggs or Tecumseh?

Sorry for all the questions,
Denis

Answer
Hello Denis:

Send me the Model Numbers Off the Unit, Please. With these I can Locate the Proper Manual and Better Assist you. Generally the identification tag is on a part of the unit that, even after years of use, rarely needs replacement. For most of MTD power equipment, these tags are approximately 2" by 3" in size. They also have the MTD Products name, address and customer service phone number listed across the bottom. For hand held product, the tag is normally white and approximately 1" by 1/2" in size. Hand held i.d. tags are normally on an aluminum portion of the engine, somewhat set into the unit to protect the label from wear. (A bar code will also be on this tag.) Riding mower tags are located on the underside of the seat. For walk behind mowers this tag is found either on the deck or on the rear door of rear discharge units. Tiller model and serial tags are generally on the tine housing. **The model and serial tags for two-stage snow throwers are located on the bottom of the main gear housing which is often called the belly pan, while single stage snow thrower tags are next to the key and primer. For other products like log splitters, chipper shredders and edgers, tags can be found on the frame or main housing.** Thanks.

Respectfully

John

PS: I am Allowed to Answer 10 Questions a Day. If you See I am Maxxed Out, then Try Submitting your Question at or Just After 8pm EST (US). My New Day Starts then. Comments and Ratings are Greatly Appreciated. Thanks.

Respectfully

John