Small Engines (Lawn Mowers, etc.): B & S 17.5 OHV engine, twin cylinder engines, compression stroke

Question
I have a 17.5 hp B & S engine model 31C707, type 0154 E1, code 040327ZD that will not start.  It has spark and I have cleaned carb and replaced gas.  Still will not start.  Turns over well but just will not start.  Any suggestions?????   Thanks

Answer
Hello Keith:

Are you Sure the Engine is getting the Proper Amount of Gas? With the Starter Turning the Engine, Spray a Small Amount of Starter Fluid or Pour a Small Amount (approximately 1oz) of Gas into the Carburetor Throat. What Does the Engine Do? Does it Start and Quit? Have you Checked the Valve Clearances? The Following is a Basic File I made for Setting the Valve Clearances. Any Input is Appreciated. **I Do Not Use the Setting Called for by the OEMs. I have Found that the Following Works Best. Remove the Valve Cover (on the Dead Cylinder for Twin Cylinder Engines). Set the Cylinder you are Setting the Valves on to Top Dead Center on the Compression Stroke When Setting the Valve Clearance. Now Loosen the Valve Adjuster Locks and Set the Intake Valve Clearance to .004in -.006in and the Exhaust to .007in - .009in. I have had Better Performance Out of the Mowers and Less Burnt Valves Using these Settings. Be Sure the Piston is at TDC on the Compression Stroke.** On Some Engines you can Us a Straightened Coat Hanger and Feel the Piston. Be Careful and Dont Jam the Wire in the Cylinder. Usually the Piston will Push the Wire Out of the Spark Plug Hole with No Problems. You can View a Breakdown/IPL of the Engine at this Site Addy; http://www.briggsandstratton.com/maint_repair/manual_and_more/doclist.aspx?categ... and Enter the Model Numbers (XXXXXX) and the First 4 Type Numbers (XXXX) in the Appropriate Boxes and Click GO. Then Select Download PDF. If you Hit a Snag or this Does Not Correct the Problem,  I am Here if You Require More Assistance. Hope this Helps. Let me Know What Happens, Please. May the All Mighty Bless You and Yours. Thanks.

Good Luck

Respectfully

John

PS: I am Allowed to Answer 10 Questions a Day. If you See I am Maxxed Out, then Try Submitting your Question at or Just After 8pm EST (US). My New Day Starts then. Ratings and Comments are Greatly Appreciated. Thanks.

Respectfully

John