Small Engines (Lawn Mowers, etc.): 16.5 hp engine single cylinder turns over half way and stop, twin cylinder engines, compression stroke

Question
Why would the engine turn over half way and stop?  Why are there wires running from a plug on the bottom of the carberator?

Answer
Hello Kenny:

1- If this is an OHV Engine, then the Valve Clearances Require Adjusting. When the Exhaust Valve Clearance Becomes too Wide, the Compression Release that Functions During Starting Fails to Function. The Following is a Basic File I made for Setting the Valve Clearances. Any Input is Appreciated. **I Do Not Use the Setting Called for by the OEMs. I have Found that the Following Works Best. Remove the Valve Cover (on the Dead Cylinder for Twin Cylinder Engines). Set the Cylinder you are Setting the Valves on to Top Dead Center on the Compression Stroke When Setting the Valve Clearance. Now Loosen the Valve Adjuster Locks and Set the Intake Valve Clearance to .004in -.006in and the Exhaust to .007in - .009in. I have had Better Performance Out of the Mowers and Less Burnt Valves Using these Settings. Be Sure the Piston is at TDC on the Compression Stroke.** On Some Engines you can Us a Straightened Coat Hanger and Feel the Piston. Be Careful and Dont Jam the Wire in the Cylinder. Usually the Piston will Push the Wire Out of the Spark Plug Hole with No Problems. 2- This Carburetor has the Anti-Diesel Solenoid. When the Ign Key is Turned Off a Plunger in the Solenoid Closes the Carburetor Jet and Fuel cannot Flow to the Engine to cause Backfire and Engine Run On. The Following is a Basic File I made for Setting the Valve Clearances. Any Input is Appreciated. **I Do Not Use the Setting Called for by the OEMs. I have Found that the Following Works Best. Remove the Valve Cover (on the Dead Cylinder for Twin Cylinder Engines). Set the Cylinder you are Setting the Valves on to Top Dead Center on the Compression Stroke When Setting the Valve Clearance. Now Loosen the Valve Adjuster Locks and Set the Intake Valve Clearance to .004in -.006in and the Exhaust to .007in - .009in. I have had Better Performance Out of the Mowers and Less Burnt Valves Using these Settings. Be Sure the Piston is at TDC on the Compression Stroke.** On Some Engines you can Us a Straightened Coat Hanger and Feel the Piston. Be Careful and Dont Jam the Wire in the Cylinder. Usually the Piston will Push the Wire Out of the Spark Plug Hole with No Problems. If you Hit a Snag or this Does Not Correct the Problem,  I am Here if You Require More Assistance. Hope this Helps. Let me Know What Happens, Please. May the All Mighty Bless You and Yours. Thanks.

Good Luck

Respectfully

John

PS: I am Allowed to Answer 10 Questions a Day. If you See I am Maxxed Out, then Try Submitting your Question at or Just After 8pm EST (US). My New Day Starts then. Ratings and Comments are Greatly Appreciated. Thanks.

Respectfully

John