Small Engines (Lawn Mowers, etc.): tiller calibration specifications, air mixture, question pool

Question
I have a tiller with a Husky engine Model #130292 Type 1673-a code 82122210, I need to know the calibrating specifications for it as I can't get it to start. (engine Husky TSc 5 hp) Thanks

Answer
Hello Sergio:

Sorry for the Delay. This Question was Located in the Question Pool. By Calibrations I am Assuming you are Asking for the Air Mixture Screw Settings.  Now Setting the Air Mixture Screws:  ****Turn the Idle Air and Main Air Mixture Screws In Until SNUG **Do Not Jam** Then Reverse Both Screws 1 1/2 Turns. Holding the Throttle Full Open, Start the Engine. Turn the Main Air Mixture Screw Clockwise Until Proper Revs are Obtained. Occasionally you May have to Turn this Counter Clockwise to Achieve the Proper Revs. Now Allow the Engine to Idle. Set the Engine Idle Screw (Not Idle Air) so the Engine will Stay Running if Required. Now Set the Idle Air Mixture Screw so there is No Hesitation when Throttling from Idle to Full Throttle. Reset the Engine Idle if Required.**** If I am Not Correct, then Please Explain in Further Detail the Calibrations you are Asking About. Thanks. If you Direct your Question to me, at or a Little After 8pm EST US, I am Not Maxxed Out and can Continue with Assisting you Directly and Not through the Question Pool Forum. Thanks.

Respectfully

John

PS: I am Allowed to Answer 10 Questions a Day. If you See I am Maxxed Out, then Try Submitting your Question at or Just After 8pm EST (US). My New Day Starts then. Thanks.

Respectfully

John