Small Engines (Lawn Mowers, etc.): Craftsman Leaf Blower, recoil starter, craftsman leaf blower

Question
Cord has broke, I have opened housing but can't seem to get pull cord back on with the right tension. Cord always wants to stick out 6-8 inches.
How do you re-install?

Answer
Hello Michael:

That Depends on the Model of the Blower. Here is the Instruction File for the Most Common Recoil on Blowers. **If the Rope has Broken and the Spring is Good, then Remove the Blower Housing (metal engine cover and recoil Starter). Remove the Old Rope from the Recoil Pulley. Now Turn the Pulley in the Same Direction that the Pulley would Turn if the Rope was Turning it. Once the Pulley will Turn No More, then Reverse Direction 1 or 2 Turns and Thread the New Rope Through the Hole in the Center of the Pulley and Out the Hole in the Blower Housing. Pull the Rope Through Until it is Tight Against the Pulley. Now Tie a Slip Knot in the Rope to Hold the Pulley in Place While the Handle is Attached to the Rope. Once the Handle is Attached, Release the Slip Knot and the Rope Should Retract Into the Housing. Reassemble the Blower Housing Onto the Engine.**  Send me the Model Numbers Off the Unit, Please. With these I can Locate the Proper Manual and Better Assist you. If you Hit a Snag or this Does Not Correct the Problem,  I am Here if You Require More Assistance. Hope this Helps. Let me Know What Happens, Please. May the All Mighty Bless You and Yours. Thanks.

Good Luck

Respectfully

John

PS: I am Allowed to Answer 10 Questions a Day. If you See I am Maxxed Out, then Try Submitting your Question at or Just After 8pm EST (US). My New Day Starts then. Thanks.

Respectfully

John