Small Engines (Lawn Mowers, etc.): engine swap, engine mod, voltage wire

Question
I am swapping engines on my gravely lawn mower. The old engine is a briggs MOD: 406777 TYPE: 0158 E1 CODE: 000424YG  with red wire from the alternater size unone the new engine MOD: 44H777 TYPE: D113 E1 CODE: 080628YC with a red and a green wire from the 16 amp alternater. What would be the proper way to connect the alternater wires?
Thank You Larry


Answer
Hello Larry:

If your Old Engine is a Single Wire Stator and the New One is a Two Wire Stator, then go to this Site Addy; http://faqs.custhelp.com/rnt/rnw/img/enduser/105-AC_DC_test_chart.jpg This is the Test Chart for the Stator/Alternator Wire System. Us the High Voltage Wire for the Battery Charging and the Lower Voltage for the Lights. If this is Not Enough Detail, then Let me Know, Please. If you Hit a Snag or this Does Not Correct the Problem,  I am Here if You Require More Assistance. Hope this Helps. Let me Know What Happens, Please. May the All Mighty Bless You and Yours. Thanks.

Good Luck

Respectfully

John

PS: I am Allowed to Answer 10 Questions a Day. If you See I am Maxxed Out, then Try Submitting your Question at or Just After 8pm EST (US). My New Day Starts then. Thanks.

Respectfully

John