Small Engines (Lawn Mowers, etc.): Toro S-200 Snow Thrower, recoil starter, slip knot

Question
I pulled cord out of my snow thrower.  I am not the most mechanical guy in the world so I am looking for instructions on how to replace the cord.  I pulled the plastic cover off and can see where the cord goes, but now what?  Thanks in advance for your help.

Answer
Hello Ed:

You can View a Breakdown/IPL of the Mower at this Site Addy, https://lookup3.toro.com/partdex/default.cfm and Select Start Parts Viewer. Now Enter the Model Numbers. Now Select View Assembly Drawings. They will Assit you in Seeing How the Unit is Assemblied. **If the Rope has Broken and the Spring is Good, then Remove the Blower Housing (metal engine cover and recoil Starter). Remove the Old Rope from the Recoil Pulley. Now Turn the Pulley in the Same Direction that the Pulley would Turn if the Rope was Turning it. Once the Pulley will Turn No More, then Reverse Direction 1 or 2 Turns and Thread the New Rope Through the Hole in the Center of the Pulley and Out the Hole in the Blower Housing. Pull the Rope Through Until it is Tight Against the Pulley. Now Tie a Slip Knot in the Rope to Hold the Pulley in Place While the Handle is Attached to the Rope. Once the Handle is Attached, Release the Slip Knot and the Rope Should Retract Into the Housing. Reassemble the Blower Housing Onto the Engine.** You Will Require the 5 or 6 Digit Toro Model Numbers. If you Hit a Snag or this Does Not Correct the Problem,  I am Here if You Require More Assistance. Hope this Helps. Let me Know What Happens, Please. Have a Happy Holiday Season and May the All Mighty Bless You and Yours. Be Safe and Happy. Thanks.

Good Luck

Respectfully

John

PS: I am Allowed to Answer 10 Questions a Day. If you See I am Maxxed Out, then Try Submitting your Question at or Just After 8pm EST (US). My New Day Starts then. Thanks.

Respectfully

John