Small Engines (Lawn Mowers, etc.): valve clearance OHV, twin cylinder engines, valve clearance

Question
John...Can you give me the cold valve clearance for a Sears pressure washer witha Briggs Intek 5.5 ohv engine # 110612 0117 E1 010122 FA

Answer
Hello Bill:

Sure. I Do Not Use the Setting Called for by the OEMs. I have Found that the Following Works Best. Remove the Valve Cover (on the Dead Cylinder for Twin Cylinder Engines). Set the Cylinder you are Setting the Valves on to Top Dead Center (Both Rocker Arms will have Play in them when the Engine is at TDC) When Setting the Valve Clearance. Now Loosen the Valve Adjuster Locks and Set the Intake Valve Clearance to .004in -.006in and the Exhaust to .008in - .010in. I have had Better Performance Out of the Mowers and Less Burnt Valves Using these Settings. Hope this Helps. I am Here if You Require More Assistance. Let me Know What Happens, Please. Thanks.

Good Luck

Respectfully

John

PS: I am Allowed to Answer 10 Questions a Day. If you See I am Maxxed Out, then Try Submitting your Question at or Just After 9pm EST (US). My New Day Starts then. Thanks.

Respectfully

John