QuestionMy B&S 6.5hp craftsman mower will only turn out when the primer is pushed about 8-10 times, and then it's only for a second before it dies out. I got it to stay running by continuing to push the primer - but that's the only way it stay running. What do you think? Thanks.
AnswerAdam
It is time for a carburetor rebuild as the jets are clogged and the diaphram may be broken.
The optimal air:fuel ratio is around 14:1. This must be lower for a cold engine and thus a choke plate or other means to increase the richness of the mixture is usually provided. A choke plate restricts air intake forcing more gas to be sucked into the cylinder. A primer bulb effectively squirts gas into the intake pipe to augment the normal carburetor action. Some carburetors have no choke and no primer but incorporate a small gas reservoir which fills when the engine is off and provides some extra when starting.
To much air results in a mixture that is too lean, burns too quickly, and can result in engine damage over extended periods of operation.
Check that any choke is not stuck in the open position and not doing its job.
The carburetor may need adjustment or cleaning.
Too little air results in a mixture that is too rich - there will be loss of power and possibly black smoke from the exhaust. This could be due to several factors:
Check the air filter. For testing, it can usually be removed to see if the engine will start. However, do not run it for an extended period of time without a properly functioning air filter in place. Some are designed to be washed and reused while others must have their elements replaced.
Check that any choke is not stuck closed. Though needed to start cold, if the choke remains closed, the engine will not restart and will quickly stop (truly choke!) due to an overly rich mixture.
A defective carburetor may also cause the mixture to be too rich or too lean.
