Toyota Repair: Fuel system, jumper wire, terminal diagram

Question
I have a 92 toyota pu it set for a year i drained the gas and put freash in i descovered the fuel pump was bad and i replaced it (22 re engine )it appears there is no power to the fuel pump i checked the efi relay by switching it with the starter relay they are both the same but still no power is there any thing else that controls the power to the pump be sides the relay and the efi fuse

Answer
Open the diagnsotic connector under the hood, the cover says DIAGNOSTIC on it. Inside the cover is a terminal diagram, locate the terminals fP and B+ and put a jumper wire between them then try to start the engine or check the fuel pump, it should run as long as the key is on, let me know if the pump works then.