Toyota Repair: 94 Corolla hub & bearing replacement, drift pin, steering knuckle

Question
I have the steering knuckle off the car and want to replace the hub and bearing.  I even have the clip ring removed and I have a ball joint press, but I need to know where to go from here.  Thanks,   Frank

Answer
The hub can be removed with a large hammer and a drift pin that just fits inside the splined hub, a bearing installing tool also works, once the hub is knocked out of the bearing the bearing has to be pressed out of the knuckle, then the new bearing is pressed in, the snap ring istalled and then the hub is pressed into the bearing, after the bearing seats it should have about 10 tons pressure applied on the hydraulic press.