Toyota Repair: 85 Celica ignition issue, position sensors, code id

Question
Just happened today.  85 celica, 300k miles, engine died while driving, check engine light came on, trouble codes 3 and 10. Checked fuses and wiring. No irregularities seen.  After several minutes, restarts and drove for about a block, died again. Believe it to be ignition related but identification specific part that failed would be great. Am I correct in trouble code "ID" and if so what can I do to trouble shoot specific part that is failing/or failed.

Answer
Toyota records don't go back that far that I have acess too here.
You're corect in ID'ing it.
3 = ignition signal
10 = starter signal
I would inspect the crank & camshaft position sensors located in the distributor.
Without either there is no fuel, or spark.