Auto body repair & detailing: removing rear window 98 F-150, auto glass company, phillips screws

Question
QUESTION: How do I get my rear window out and replase the seal to keep water from leaking inside?

ANSWER: Hi Barney
You will have to pull the rubber seal out and release the rubber and glass together as a unit- always good to have a second person on the outside while you will have to pry the rubber lip over the rear window flange. Try and use plastic leverage tools as metal can damage the glass. There is a tool designed for the rubber seal for reinstallation. You will also be required to use a very thin nylon rope for installing(pulling) the glass.It is also a very quick and easy job for your local auto glass company.  Hope this helps and all the best to you.........Kim

---------- FOLLOW-UP ----------

QUESTION: Kim
My pick-up is an extended cab with a bolt-in rear window.
My problem is that I don't know how to remove the inside trim and back of seat to get to the bolts.
Thank you for any help you can give.
Barney

Answer
Hi Barney
The seat may have to be removed , It will be bolted down through the floor...The inner trim should be held in place by means of Phillips screws and clips that are bnot apperent from the outside of the panel...These have to be released by carefull prying.. This is about all I can tell you about the interior panel  Go careful so as not to break of the tabs.....All the best to you......   Kim