Car Alarms: PLEASE HELP!!!!, vw jetta, keyless entry system

Question
I have a 1995 Vw Jetta. My boyfriend tried putting a car stereo in for me and some how something went seriously wrong. After he was finished the stereo worked ok for an hour or so but after that our car alarm kept going off. The only thing we could do was take out the fuse. Well even with the fuse back in place and the new stereo also out, now when I try to start my car it turns over but wont start. Its not getting any fuel or a spark. WHAT DO I DO???? PLEASE HELP!!!!

Answer
Ok, a bit complicated.
 This system depends on the physical action
of the door lock locking and unlocking-arming and disarming.
If you have a factory remote, that would do this to
specifications.

This can only be achieved 3 ways:

1. Use key in the drivers door, turn left,
then right to disarm and unlock.

2. Add an after market keyless entry system to emulate
the factory remote functions. I have several models
if this option suits you.

3. Acquire or use & or, replace the original remote that
can control it as specified. This would be at the
local dealership parts department.

(This is why there is no wire you could ground
without affecting the door lock system.
A single negative pulse to the unlock wire will disarm
without unlocking, yes, but would always disable the
locking mechanism. Not good.)

Keep in mind, if this is after market
(siren and flashing parking lights)
then it's a different method entirely.

The standard method to disables as follows:

Look under the dash area for a button or, a toggle
switch. When you locate it, turn on the ignition
key, press and hold in the button (little
spring loaded micro button, red or black possibly)
until the alarm chirps 1 time. This should over ride
the system, and only the keyless entry part,
if installed, would still be operating.
The LED (light emitting diode) light in the dash
should also go on solid. If it's a toggle type,
then key on, flip the switch in the other direction
This would be OVERRIDE/VALET mode.

Repeat this process to toggle back to service mode.

Let me know what applies
to your issues.

R. Martin - ALARMTEK