Car Alarms: 1996 camry alarm system, valet mode, dash area

Question
i do not have remote control for this vehicle, only keys, the security system appears to have armed itself while the battery cable was disconnected. this system is now armed and will not start. how do i disarm with just keys?

Answer
Right, Ok, try this.
Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, press and hold in the valet/overide
button, found under the dash area, usually to the left
of the leg, drilled into a plactic panel.
Might even be part of an on glass antenna
in the widshield if it's a remote starter,
until the installed LED (the blinking light)
in your dash area goes off, and the siren chirps twice.
(Your valet switch might be the toggle (on/off) type.
in this case, key on, flip switch in oposite direction,
key off.)

This should reset the alarm and allow you to
go on your way.

Just Repeat these steps to place it
back to valet mode.

That should do it.

Good luck.

ALARMTEK