Car Alarms: Try the following, valet mode, chrysler new yorker

Question
QUESTION: I have a 1993 chrysler new yorker and i just want to know how to reset the alarm system because it does not let me turn the car on.

ANSWER: The standard method to disables as follows:

Look under the dash area for a button or, a toggle
switch. When you locate it, turn on the ignition
key, press and hold in the button (little
spring loaded micro button, red or black possibly)
until the alarm chirps 1 time. This should over ride
the system, and only the keyless entry part,
if installed, would still be operating.
The LED (light emitting diode) light in the dash
should also go on solid. If it's a toggle type,
then key on, flip the switch in the other direction
This would be OVERRIDE/VALET mode.

Repeat this process to toggle back to service mode.

That's all I have on this car.

R. Martin - ALARMTEK

---------- FOLLOW-UP ----------

QUESTION: but where exactly under the dash is the button so i wouldn't have to take
everything off?

Answer
Ok, an installer would place the velet switch in a semi
hidden area. I'd look under the dash area
for a button or, a toggle switch. When you locate it,
turn on the ignition key, press and hold in the
button (little spring loaded micro button, red or
black possibly), until the alarm chirps 1 time.
This should over ride the system, and only the
keyless entry part, if installed, would still be
operating.

The LED (light emiting diode) light in the dash
should also go on solid.=VALET/OVERIDE

This stops the alarm except for the keyless
entry if installed. Once in Valet mode,
it will allow the car to start and operate
like there was no alarm at all.

The next step is if wanting to remove it,
you contact a local technician to
locate it, and affect neccesary service
for you.

That should solve the troubles.

Let me know what you discover.

ALARMTEK
CARALARMMAN.COM