Car Alarms: Keyless entry system, valet mode, eddy bauer

Question
The remote control for my 1998 Ford Explorer (Eddy Bauer model) locks and unlocks doors, but does not "chirp" or activate light flashing.  The alarm sounds when activated but the lights don't flash.

Answer
Should be no problem really.
It appears from your expaination, that the
car alarm is in service mode.

Ok, try this.
Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, press and hold in the valet/overide
button, found under the dash area, usually to the
left of the leg drilled into a hidden away spot,
until the installed LED (the blinking light)
in your dash area goes off, and the siren chirps twice.
(Your valet switch might be the toggle (on/off) type.
in this case, key on, flip switch in oposite direction,
key off.)

This should reset the alarm.

Just Repeat these steps to place it
back to valet mode.

That should do it.
Let me know what happens.

ALARMTEK
INSTALLSUPPORT.COM