Car Alarms: Pursuit alarm doesnt beep, car alarm system, double beep

Question
I have a pursuit car alarm system that was working perfectly, and last week
all of a sudden when I press the controller to unlock it, it doesn't make the
double beep, and when I press it again to lock it, it doesn't do the single
beep.  The car is still locked and armed , but the controller doesn't make any
sound.  The problem is that it is difficult to know if I have pressed the
controller twice or once and I have to physically look to see if the doors are
actually locked or not.  I don't have a manual.  

Answer
Should be no problem really.
It appears from your expaination, that the
car alarm is in service mode.

Ok, try this.
Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, press and hold in the valet/overide
button, found under the dash area, usually to the
left of the leg drilled into a hidden away spot,
until the installed LED (the blinking light)
in your dash area goes off, and the siren chirps twice.
(Your valet switch might be the toggle (on/off) type.
in this case, key on, flip switch in oposite direction,
key off.)

This should reset the alarm.

Just Repeat these steps to place it
back to valet mode.

That should do it.
Let me know what happens.

ALARMTEK
INSTALLSUPPORT.COM