Car Alarms: my car wont start, chrysler lhs 1994, chrysler lhs

Question
I am a 25yr old sinfle mother of two. i owna chrysler LHS 1994. my car won't start and the light on my dash is blinking. it will start for a second then cuts out and it is making a ticking noise from the driver side. i have little money to bring it in so if you have any suggestions on anything i can do i am desperate. thank you i really appreciate it.
God Bless,
April Hill
you can also call me at
719-632-6044
it's my mothers number i am here all day till 8 pm.


Answer
Not sure what aftermarket system you have
there, but it's not a factory alarm.
This is what I think is going
on....

The alarm seems to be in long tamper mode.
You will need to reset, and possibly
re program the remotes. That part you will need
your manual for, but the aftermarket alarm
seems to be doing it's job.

At least we know it's installed correctly
which is actually a good thing here.

Ok, try this.
Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, locate, press and hold in the
valet/overide button, found under the
dash area, (push button, spring loaded)
until the installed LED (the blinking light)
in your dash area goes on solid,
and the siren chirps once.

(Your valet switch might be the toggle
(on/off) type. in this case, key on,
flip switch in opposite direction,
then turn the key off.)

This should reset the alarm, and reset
the grounded relay on the starter wire,
allowing you to start the engine.

At this point, the only thing working would
be the keyless entry from the alarm,
if it came equipped that way.

Just Repeat these steps to place it
back to usable armed mode.
You may get 2 chirps, confirming it,
and the lights may flash twice as well.

That should do it.
If you want to remove it at this point,
take it to your neighborhood installer
for this.

Let me know what happens.

ALARMTEK
INSTALLSUPPORT.COM