Car Alarms: mercury villager 96antitheft system, mercury villager, valet mode

Question
the battery of my van was death when I changed it the van does not start up.. is like the antitheft system don't allow me to do anything in the van.. the remote or bepper for the alarm does not do anything neither....

Answer
Ok, to start, look under the dash area for a button or,
a toggle switch. When you locate it, turn on the
ignition key, press and hold in the button (little
spring loaded micro button, red or black possibly)
until the alarm chirps 1 time. This should over ride
the system, and only the keyless entry part,
if installed, would still be operating.
The LED (light emiting diode) light in the dash
should also go on solid.=VALET/OVERIDE

This stops the alarm except for the keyless
entry if installed. The next step is to
either remove the alarm or, try to identify,
and get new remotes for it.

But once in Valet mode, it will allow the car
to start and operate like there was no
alarm at all. Repeat steps to put into user
mode.

Let me know how it goes.

ALARMTEK
CARALARMMAN.COM