Car Alarms: 2000 accord factory alarm problem, power window switch, dash area


Question
I have a 2000 accord ex with a factory alarm that for last 10 days or so goes off randomly once or twice a night (lights flashing and honking.  Is there a way to reset or disable this alarm so I can get some sleep?  Please advise, thanks.

Answer
2 ways of going here according to your description.

Normally, you would insert the key in
the drivers door, turn left, then right
to disarm and reset it. If yours is malfunctioning,
you can disable it for good by doing the following:

On the EX the BLUE wire is located at the drivers
power window switch, on the LX the BLUE wire is at the
keyless/security unit which is attached to the drivers
underdash panel.

Once Located, splice into this wire with
a simular guage wire, and put it to
a solid chassis ground. This terminates
the alarm functions entirely.

However, at this point, this car would be exceedingly
easy to steel, so I suggest you get an aftermarket
alarm system to protect it from here on in.

Now, if this is already an aftermarket
system you have there, try this.

Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, locate, press and hold in the
valet/overide button, found under the
dash area, (push button, spring loaded)
until the installed LED (the blinking light)
in your dash area goes on solid,
and the siren chirps once.

(Your valet switch might be the toggle
(on/off) type. in this case, key on,
flip switch in opposite direction,
then turn the key off.)

This should reset the alarm, and reset
the grounded relay on the starter wire,
allowing you to start the engine.

At this point, the only thing working would
be the keyless entry from the alarm,
if it came equipped that way.

Just Repeat these steps to place it
back to usable armed mode.
You may get 2 chirps, confirming it,
and the lights may flash twice as well.

That should do it.

Have a good day.

ALARMTEK
CARALARMSTORE.com