QuestionKevin, where is the leak detection pump soleniod located. i was told, next to the gas tank an it not there.i see vacuum soleniond under the hood one by the right front corner and the other on the left back corner of the block. any info would be helpful thanks
AnswerLEAK DETECTION PUMP
REMOVAL
1.Release fuel pressure, Refer to Fuel System Pressure Release Procedure in the Fuel Delivery section.
2.Disconnect battery cable Battery Cable
3.Raise vehicle and support
4.Drain fuel tank, refer to Draining Fuel Tank in the Fuel Delivery section Fuel Tank Drain
5.Loosen and remove fuel filler tube from fuel tank Fuel Filler Tube
6.Disconnect fuel line Fuel Line
7.Position transmission jack under fuel tank assembly.
8.Remove fuel tank straps bolts. Passenger side first.
9.Lower fuel tank and remove the purge line and vent line Evap Components
10.Remove hoses from EVAP canister.
11.Disconnect electrical connector for Leak Detection Pump (LDP)
12.Remove push pin from bracket for EVAP canister LDP and EVAP Canister
13.Remove bracket and Leak Dectection Pump.
14.Remove LDP from bracket.
INSTALLATION
1.Install LDP onto bracket.
2.Install bracket and LDP onto fuel tank assebly.
3.Install EVAP canister to bracket install push pin.
4.Install hoses and lines.
5.Raise the fuel tank on the transmission stand.
6.Connect the purge and vent lines.
7.Connect LDP and fuel pump electrical connector.
8.Raise tank into position and install tank straps.
9.Install the fuel filler tube and tighten the clamp.
10.Lower vehicle.
11.Connect the battery cable.
12.Fill fuel tank. Use the DRB scan tool to pressurize the fuel system. Check for leaks.
