QuestionQUESTION: Can you give me instructions on how to replace my driver's side rear view mirror? 2006 Chrysler Sebring
Thanks!!!
Peggy
ANSWER: REMOVAL
1. Remove side view mirror cover Fig. 1 .
2. Remove the door trim panel (Refer to 23 - Body/Door - Front/PANEL, Door Trim - Removal) .
3. Disconnect power window mirror motor wire connector, if so equipped.
4. Disengage wire harness grommet from mirror flag, if so equipped.
5. Disconnect manual mirror adjuster from side mirror cover, if so equipped.
6. Remove nuts attaching side view mirror to mirror flag Fig. 2 .
7. Remove side view mirror from vehicle.
Fig. 1 - Side View Mirror Cover
1 - MIRROR FLAG
2 - SIDE VIEW MIRROR COVER
3 - FASTENERS
---------- FOLLOW-UP ----------
QUESTION: I need help with #2 "Remove the door trim panel."
Can you send me directions please? And diagrams would help a lot!!
Thanks so much!
Peggy
Answer
pic
REMOVAL
1. Roll door glass down.
2. Disengage two clips attaching speaker grille to door trim panel. They are at the front of the grille, one near the top, and the other one at the bottom.
3. Remove three large washer-headed screws surrounding the speaker Fig. 1 .
4. Remove access cover at front of door trim panel. Remove by prying at its rear edge Fig. 2 .
5. Remove red courtesy reflector from lower tail or door. Disengage by prying at screwdriver notch at bottom of reflector.
6. Remove flag trim panel from door by prying off at two attachment clips points Fig. 2 .
7. Remove seven screws attaching door trim panel to door: Fig. 1 and Fig. 2 . a. One screw is located at lower rear screw pocket.
b. Three screws located along the bottom of door.
c. One screw located inside handle opening.
d. One screw located at the upper front.
e. One screw in the pull cup.
8. Disengage two hidden clips attaching at the rear of the trim panel, by prying off at two attachment clip points.
9. Lift trim panel upward and away from door, disengage trim panel from upper retainer channel.
10. Disengage clip attaching latch linkage to back door handle.
11. Disconnect electrical connectors as necessary, including lower foot light, If equipped.
12. Remove door trim panel from door.
