Dodge Repair: drivers doors power window, dodge caravan, door switch

Question
Hello. I've a 2003 Dodge Caravan with an intermittently working power window (driver's door). What must I do to correctly remove the door panel in order to get to the window's drive motor and actuator? Thanks in advance.

Answer
REMOVAL
Remove the plug and remove screw attaching door pull cup to inner door panel.
Remove switch bezel and disconnect power window/memory switch.
Remove screws attaching trim panel to door from below map pocket.
If equipped, remove window crank. (Refer to 23 - BODY/DOOR - FRONT/WINDOW CRANK - REMOVAL)
Remove screw holding door trim to door panel from behind inside latch release handle .
Disengage clips attaching door trim to door frame around perimeter of panel.
Lift trim panel upward to disengage flange from inner belt molding at top of door.
Tilt top of trim panel away from door to gain access to latch linkage.
Disengage clip attaching linkage rod to inside latch release handle (INSIDE DOOR HANDLE LINKAGE).
Separate linkage rod from latch handle.
Disconnect the power door switch, courtesy lamp electrical connectors.
Remove front door trim panel from vehicle.