Dodge Repair: 02 Dakota Central Timing Module, airbag deployment, panel component

Question
Where is the Central Timing Module located and how do you replace it?

Answer
REMOVAL
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, SEAT BELT TENSIONER, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE AIRBAG SYSTEM CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE AIRBAG SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.

NOTE: Before replacing a Central Timer Module (CTM), use a DRBIII® scan tool to retrieve the current settings for the CTM programmable features. Refer to the appropriate diagnostic information. These settings should be duplicated in the replacement CTM using the DRBIII® scan tool before returning the vehicle to service.

Disconnect and isolate the battery negative cable.
Remove the trim from the left cowl inner panel. (Refer to 23 - BODY/INTERIOR/COWL TRIM COVER - REMOVAL).
Disconnect the wiring harness connectors from the CTM. (Central Timer Module).
Remove the screws that secure the CTM to the left cowl inner panel.
Remove the CTM from the left cowl inner panel