Jeep Repair: Parking brake cable snapped on Grand Cherokee 2002, grand cherokee 2002, parking brake cable

Question
How do I replace the parking brake cable on my Jeep Greand cherokee laredo 2002? The cylindrical piece on the end of the cable which comes up through the floor board and connects to the parking brake lever snapped off. I have the replacement cable but am not sure if there are any special concerns or "tricks" involved with installing it.

Thank you.

Answer
REMOVAL - FRONT PARKING BRAKE CABLE
Remove center console,(Refer to 23 - BODY/INTERIOR/FLOOR CONSOLE - REMOVAL).
Lift up rear seat and carpet covering the parking brake cables.
Place a screw driver through the front cable eyelet (Front Cable Eyelet) and pry back on the front cable.
Have an assistant pry down the lock out spring through the hole in the side of the park brake lever (Lock Out Spring) with a small screw driver. Then slowly release the front cable.
NOTE: Their should be slack in the cable if the lock out spring is engaged.

Disengage front cable end from the equalizer (Cable Equalizer).
Disengage front cable end from the parking brake lever.
Remove the front carpet,(Refer to 23 - BODY/INTERIOR/CARPETS AND FLOOR MATS - REMOVAL).
Remove front cable retainer nuts (Front Parking Brake Cable) from the floor pan.
Compress the cable retainers with a 13 mm wrench (Brake Lever Bracket). Remove the cable from parking brake lever bracket and equalizer bracket.