Jeep Repair: starter, jeep grand cherokee laredo, jeep grand cherokee

Question
Could I have a step by step procedure for replacing a 1999 jeep grand Cherokee Laredo, 4.0 4wd

Answer
STARTER MOTOR
REMOVAL
Disconnect and isolate the battery negative cable.
Raise and support the vehicle.
Remove the lower (forward facing) mounting screw securing the starter motor to the automatic transmission torque converter housing Starter Motor Remove/Install - 4.0L Engine or Starter Motor Remove/Install - 4.7L Engine
While supporting the starter motor with one hand, use the other hand to remove the upper (rear facing) mounting screw securing the starter motor to the automatic transmission torque converter housing.
Lower the starter motor from the front of the automatic transmission torque converter housing far enough to access and remove the nut that secures the battery cable eyelet to the solenoid battery terminal Starter Wire Harness Remove/Install - 4.0L Engine or Starter Wire Harness Remove/Install - 4.7L Engine Always support the starter motor during this process, do not let the starter motor hang from the wire harness
Remove the battery cable eyelet from the solenoid battery terminal. Always support the starter motor during this process, do not let the starter motor hang from the wire harness.
Disconnect the solenoid terminal wire harness connector from the connector receptacle on the starter solenoid. Always support the starter motor during this process, do not let the starter motor hang from the wire harness.
Remove the starter motor from the engine compartment.
INSTALLATION
Position the starter motor in the engine compartment.
Reconnect the solenoid terminal wire harness connector to the connector receptacle on the starter solenoid. Always support the starter motor during this process, do not let the starter motor hang from the wire harness.
Install the battery cable eyelet onto the solenoid battery terminal. Always support the starter motor during this process, do not let the starter motor hang from the wire harness.
Install and tighten the nut that secures the battery cable eyelet to the solenoid battery terminal. Tighten the nut to 10.2 N·m (90 in. lbs.) Always support the starter motor during this process, do not let the starter motor hang from the wire harness.
Position the starter motor to the front of the automatic transmission torque converter housing and loosely install both the upper and lower mounting screws.
Tighten the lower (forward facing) starter motor mounting screw. On 4.0L engines, tighten the screw to 41 N·m (30 ft. lbs.) On 4.7L engines, tighten the screw to 54 N·m (40 ft. lbs.)
Tighten the upper (rearward facing) starter mounting screw. Tighten the screw to 54 N·m (40 ft. lbs.)
Lower the vehicle.
Reconnect the battery negative cable.