Small Engines (Lawn Mowers, etc.): 21 Sears 6.75 Hp Push Mower, wd 40, liquid wrench

Question
The chord that you pull to start the engine gets stuck quite often and I have to use a screwdriver to push the "flywheel" which then winds the chord back.
I need to do this several times until engine starts and then once it starts the rope stays unwound and I have to wrap it around the handle until I finish mowing a couple of hours later and do the screwdriver bit again.
Any easy way to fix this? I have sprayed some oil at the top of the flywheel to no avail.
Thanks,
Bill

Answer
You can remove the starter, 2 screws on top of the engine housing, and then use some WD-40 or Liquid Wrench to lubricate the starter pulley spring.

With the starter removed you will be able to see the rewind spring retaining point on the starter pulley.  The WD-40 tube will fit inside this area and allow you to lubricate the starter spring.

Let me know if this helps.
Eric