Toyota Repair: 93 tacoma pick stallin, camshaft position sensor, mass air meter

Question
I'm helping my buddy work on his tacoma it has the 4cyl. We just replaced the water pump and now the truck will start, but when you push the gas it stall, and when it starts to warm up it'll stall and shut off. We've already replaced the coil, and the fuel pump was replaced about a month ago. We're not sure what is wrong. Thanks for the help

Answer
Isaac,

I would start by carefully looking over your wires and connections to the crankshaft position sensor and the camshaft position sensor. Both are up front near the water pump area so it may have gotten bumped loose. Next, make sure there are no air leaks in the tube between the throttle body and Mass Air Meter. Also, check that the Mass Air Meter is fully plugged in.

Let me know if you guys find anything or what else I can help you with.