Checking a Mitsubishi Eclipse for ignition system problems mainly involves testing the resistance on the ignition coils (although there are other tests you can perform first if it's a distributor system). The way in which you test these coils varies depending on the type of ignition system and the size of the engine.
Secure the Eclipse by putting the gear shift in "Park" and applying the emergency brake.
Perform the cylinder drop test with the engine idling. Remove a spark plug with insulated pliers for a few seconds. Inspect the plug and wire if the removal doesn't cause a drop in engine performance. Shut off the engine after all plugs are tested.
Test the spark plug wires with the secondary spark test. Connect a spark tester to the disconnected wire, ground the tester to something metal and crank the engine. The wire is good if a strong blue spark appears.
Unplug the electrical connector and measure the resistance between the two terminals with an ohmmeter. For 2.0L and 3.0L engines this is done at the coil. Probe the terminals at the distributor for other engines.
Measure the resistance between the secondary ignition coil terminal on the distributor cap and terminal 1 or 2 of the distributor connector.
Compare the measured resistance to the required specifications for your Eclipse's engine (refer to the Tips for the list). Replace any coils that don't meet the requirements.
Unplug the Eclipse's negative battery cable. Disconnect the electrical connector from the coil pack.
Use an ohmmeter to check the resistance between the coil pack's terminals. On a 3.0L engine, measure between terminals 2-3 on Coil A, 1-3 on Coil B and 4-3 on Coil C.
Check the measured resistance with the required primary resistance. It should be between 0.74 to 0.90 ohms on a 2.4L engine and 0.67 to 0.81 ohms on a 3.0L engine.
Disconnect the spark plug wires from the coil on a 2.4L engine. Tag the wire so you'll know where to reconnect them. Measure the secondary resistance between each individual coil's towers, which should be 20.1 to 27.3 kilo-ohms.
Probe the following coil pack cylinder terminals on a 3.0L engine: Terminals 1-4 for Coil A, 2-5 on Coil B and 3-6 for Coil C. The secondary resistance on each should be 11.3 to 15.3 kilo-ohms.
