Car Alarms: Car alarm, dash area, flip switch

Question
I have a '96 4Runner and it will not start. I have replaced the starter and starter relay switch(?) and it still will not start. I tried starting it on Tuesday of last week and it just clicked and when I went to get out of the vehicle the alarm went off. I was unaware it had an alarm. I do not have a key pad to turn it off. I only have a basic key. Is it possible that the alarm has locked the motor and will not allow me to start it. How do I disarm it or disconnect it so it will start again?

Answer
Ok, since it's after market,
try the following:

PUT IGNITION KEY IN IGNITION,
KEY ON TO JUST BEFORE CRANKING THE ENGINE.
PRESS IN AND HOLD VALET SWITCH FOUND UNDER THE DASH
AREA UNTIL YOU GET A RESPONCE FROM THE ALARM.

KEY OFF.

This should toggle the alarm in and out of
valet/override.

If toggle type switch.
KEY ON, FLIP SWITCH, KEY OFF,
START THE CAR.

If this is not solving the issue,
please go to the site we set up
to deal with all of these requests
for disarming the security in any
given vehicle. It is a liability to
publicly share that level of information
here at ALLEXPERTS.

Obviously, posting this sort of sensitive information
for all to see and implement is not a good idea.
Since we are liable if my info is used to perpetrate a crime,
we sell it for a very modest fee, and keep track of who buys
it in case it should come back to us for review.

If wanting this information to solve your disarming issue.,
please go to DISARMALARM.com so I can get you the
info you require to fix your particular situation.

I hope to be able to help you
with this problem in the near future.

Robert Martin-
ALARMTEKONLINE-
DISARMALARM.com