Car Alarms: car alarm remote broke, valet service, dash area

Question
i have an excalibur alarm on my truck, and i have only 1 remote and it got wet, and now my truck wont start because i cant reset the alarm. what do i need to do, or how do i bypass the alarm so i can start my truck? when i turn the key forward it beeps but wont let me start the vehicle.

Answer
Gotcha, let's put it into valet/service mode,
and try to reset the alarm to default mode.

Look under the dash area for a button or, a toggle
switch. When you locate it, turn on the ignition
key, press and hold in the button (little
spring loaded micro button, red or black possibly)
until the alarm chirps 1 time. This should over ride
the system, and only the keyless entry part,
if installed, would still be operating.
The LED (light emiting diode) light in the dash
should also go on solid.

At this point. the alarm would have reset.
If this had a starter kill relay installed,
it would now be opened, and the engine would
turn over when tried.

You would repeat these steps to go back to
user mode to see if this was corrected.

Let me know if it works for yours.

ALARMTEK
INSTALLSUPPORT.COM