Car Alarms: starter kill, valet mode, dash area

Question
My after market alarm system has a start kill. Its been avting up, as in I can't turn my car on about once a week. Everytime it happens I give it a few hours and I go and try to start her up and she turns on and I can drive. Is there a set amount of time a kill switch needs to reset? Is that what's happening?

Answer
Hmmm, might need to be evaluated by a tech to
trouble shoot the issue. Until then, to try to disarm it,
look under the dash area for a button or,
a toggle switch. When you locate it, turn on the
ignition key, press and hold in the button (little
spring loaded micro button, red or black possibly)
until the alarm chirps 1 time. This should over ride
the system, and only the keyless entry part,
if installed, would still be operating.
The LED (light emiting diode) light in the dash
should also go on solid.=VALET/OVERIDE
( if this is a remote starter, the antenna on the
front window glass may also have the over ride
button inset into it.)

This stops the alarm except for the keyless
entry if installed. Once in Valet mode,
it will allow the car to start and operate
like there was no alarm at all.

The next step is if wanting to remove it,
you contact a local technician to
locate it, and affect neccesary service
for you.

That should solve the troubles.

Let me know what you discover.

ALARMTEK
CARALARMMAN.COM