Car Alarms: Replaced battery/Crimestopper Car Starter, valet mode, subaru legacy

Question
My husband recently replaced the battery in my 1999 Subaru Legacy.  My son was able to reset the locks manually and now my remote will work for the locks but my automatic start does not work.  Does anyone have any ideas what to do to reset the crimestopper auto start?  I would greatly appreciate any help you can offer!

Answer
Should be no problem really.
It appears from your expaination, that the
after market car system is in service mode.

Ok, try this.
Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, press and hold in the valet/overide
button, found under the dash area, usually to the
left of the leg drilled into a hidden away spot,
until the installed LED (the blinking light)
in your dash area goes off, and the siren chirps twice.
(Your valet switch might be the toggle (on/off) type.
in this case, key on, flip switch in oposite direction,
key off.)

This should reset the system, and allow you to remote start.

Just Repeat these steps to place it
back to valet mode.

That should do it.
Let me know what happens.

ALARMTEK
INSTALLSUPPORT.COM