Car Alarms: Alarm problem, valet service, acura integra

Question
Hi, I have an Acura Integra and had a Bicron Alarm installed a while back and now I can't get my car started due to the engine ignition killer. I'm pretty sure it's from the alarm, i tried to pump the clutch and turn the engine, it worked a few times before, now doesn't work at all. I sometime hear the alarm chirp when i pump the clutch a lot and trying to start the same time. Is there a way I can disconnect the alarm permanently without having to take the whole thing out(i don't know how to take the whole thing out also). The shop where i got it installed when out of bussiness and i don't know any other place that carries Bicron alarms . Please help, my car is sitting in the parking lot for a week now. Sucks.... THanks a lot

Answer
Ok, alarm seems to be in long tamper mode.
Let's try to put it into valet/service mode.

Look under the dash area for a button or, a toggle
switch. When you locate it, turn on the ignition
key, press and hold in the button (little
spring loaded micro button, red or black possibly)
until the alarm chirps 1 time. This should over ride
the system, and only the keyless entry part,
if installed, would still be operating.
The LED (light emiting diode) light in the dash
should also go on solid.

This solves the problem for now.

Then if you want to remove it, take it to a local
after market alarm dealer and have it done there.

They may even be able to reset/reprog. the features on
the alarm you have, to allow you to use the system
more comfortably, but of course, your call.

Have a nice afternoon.

ALARMTEK
INSTALLSUPPORT.COM