Car Alarms: factory alarm wont reset ,how can i disable alarm permently, 1996 chrysler cirrus, chrysler cirrus

Question
i cant get factory alarm to reset. how can i do away with the factory alarm on this 1996 chrysler cirrus?

Answer
This one is tricky. The Cirrus is a difficult vehicle
to work on and it can be expensive. If it's an aftermarket
alarm, look at the last few posts to get valet overide
info, and apply.

If it's factory, then it's going to be a surgical
application using relays and resistors. Dodge/Chrysler
is the best place for this, or a good stereo/car alarm
shop.

Here's how to tell one from the other:

HEADLIGHT FLASHING & CAR HORN HONKING
AND THE WORD "SECURITY" OR ANTI-THEFT
IN THE DASH=factory (OEM) alarm
or,
SIREN BLARRING AND PARKING LIGHTS FLASHING WITH
AN LED FLASHING IN THE DASH=AFTER MARKET.

If it's the factory system going off
(headlights/car horn)
Give this to your technician:

locate the green/orange |+  |in the drivers
side kick or at the Body Control Module.

Lt. green/orange from driver's door or dk. green/orange
from passenger or catch either at BCM located behind
right side dash. Use a positive (+) trigger thru
a 940 ohm resistor to arm, and a positive (+) trigger
thru a 470 ohm resistor to disarm.
Must use positive relays.

Just hope it's the former, not the latter here
for you wallets sake.

I hope this helps you.

ALARMTEK
CARALARMSTORE.com